Skip to content
Diagnosis & repairBy Barry Andrews

No Hot Water: Who to Call and What to Have Ready

A triage for cold water at the tap: what to check first, when to call a plumber rather than a neighbour, and what information makes the first visit count.

Cold water at every tap is the most common water heater complaint and the least likely to be an emergency. Four causes cover most of them, and three of those are answered in five minutes without tools.

First, the three cheap checks

The breaker. On an electric tank, a tripped breaker is the single most common cause, and it is often tripped by a failing element rather than by chance. If it trips again immediately, stop resetting it: something is drawing too much.

The gas. Has the appliance valve been closed, by a contractor, a tenant or during work on the property? Is the pilot out, or has the unit locked out after repeated ignition attempts? On propane, check whether the tank has gas.

The valve at the heater. A supply valve left part-closed after other work can reduce flow enough to feel like a failure, especially at a shower.

Then, the patterns worth recognising

Hot water that fades faster than it used to. On an electric tank, a failed lower element or thermostat can leave the household with only the top element heating. On any tank, a broken dip tube lets cold water mix at the outlet.

Hot water that is warm but never hot. A thermostat set low, a mixing valve doing its job, or a crossover fault where hot and cold meet somewhere they should not.

Hot water in one place only. That is plumbing rather than the heater, and the fixture or the run is the suspect.

Hot and cold alternating or knocking. Scale, sediment or a failed element, and the noise is the tank telling you which.

When it is genuinely urgent

Water leaving the tank, a smell of gas, a burner that will not stay lit and smells of fuel, or a relief valve that keeps running. Those belong with the emergency hub, which covers the shutdown order before anyone diagnoses anything.

A tank that is dry and energised is the other urgent case. If the power is on and the tank may have drained, switch the breaker off first.

What to have ready for the call

  • Whether the unit is gas, electric or propane.
  • The make and model, read off the rating plate or sent as a photo of it.
  • What the breaker, the gas valve and the pilot are doing.
  • Whether the property is on a well or a utility, and whether water pressure has changed.
  • Any recent work on the plumbing or the street.

That answers most of the diagnosis before anyone drives out, and it turns a first visit from a survey into a repair. The repair hub has the fault by fault version.

When the answer is replacement

If the tank has rusted through, or the fault sits in a shell that is already at the end of its life, the honest conversation is a replacement rather than a sequence of repairs. The replacement hub covers the decision, and North Pomona's repair page shows how the triage plays out on an older housing stock.

The one thing not to do

Do not relight a unit repeatedly when it will not stay lit, and do not reset a breaker that trips again immediately. Both are attempts to force a fault that has a cause, and both can turn a repair into a replacement.

Questions about this article

No hot water anywhere. What should I check first?

The obvious things: whether the breaker has tripped, whether the gas has been shut off or the pilot gone out, and whether the supply valve at the heater is open. Those three account for a surprising share of cold taps.

Hot water is running out faster than it used to. Is that a failure?

It is usually a diagnosis rather than a breakdown: a failing lower element on an electric tank, a dip tube, or a thermostatic mixing valve. It is worth a service call before it becomes an emergency.

Is no hot water an emergency?

Usually not, unless the tank is leaking, the water is escaping, or there is a smell of gas. Cold water is uncomfortable; water on the floor or gas in the air is a call now.

If I rent, who calls?

The landlord or the managing agent, and in writing if possible. A tenant should not open panels or drain equipment without permission, and the record of the report protects both sides.

Call(989) 601-2666