A tankless heater is a good answer to two problems: a household that runs out of hot water because storage is being exhausted, and a building with no room for a tank. On a Camulos parcel it brings two complications that storage units do not have, and both come from the supply rather than the appliance.
The inlet screen is the first weak point
A tankless heater passes water through narrow channels and a fine screen at the inlet. Grit that settles harmlessly to the bottom of a storage tank instead accumulates in that screen and in the heat exchanger's waterways, and the symptoms are specific: flow that drops as the unit ages, a unit that shuts off mid-draw, and scale that needs dissolving rather than flushing.
On well water, the sensible arrangement is a filter ahead of the heater, sized to the flow the unit is rated for, with a replacement schedule someone actually keeps. A tank-based unit tolerates grit better; that is a real advantage of storage and worth weighing rather than dismissing.
Scale is the second issue. No chemistry result for any Camulos-area supply was available here, so this page does not claim the water is hard. It claims that on any private supply the descaling interval should come from the water test and the manufacturer's instruction, not from a habit imported from somewhere else.
Flow is measured against the pump, not the brochure
Tankless units are rated by temperature rise against flow, and the unit only fires when flow passes a threshold. That threshold is a published number, and it is the number that matters on a well system.
A pump that holds steady pressure will carry a tankless unit comfortably. A system with a pressure tank that has lost its charge, or a pump that is cycling under a simultaneous draw, will not: flow and pressure fall together, the unit drops out, and the household gets cold water in the middle of a shower that started fine. The fix is upstream, on the pump, the switch and the tank, and the repair page covers that diagnosis.
Sizing follows from the fixtures that run at once, not from the household count. Two showers and a laundry at the same time is a different requirement from one shower, and a well's sustained yield is the ceiling on the whole conversation.
Fuel and venting carry the cost
A gas tankless unit needs a gas supply sized for its input, which is higher than a storage unit's because it heats on demand. Propane is normal on a rural parcel: no utility gas coverage for Camulos was verified, so an onsite tank, its regulator and its capacity come into the plan before the appliance does.
Venting is the second cost. A condensing unit needs a vent that suits its category and a route to outside, which may be a wall or a roof depending on the model and the building. A non-condensing unit is cheaper to vent but less efficient. Either way, the vent route is a site question, and a long run or a shared chase adds cost that does not appear on the unit's price.
Condensate is the detail that surprises people. A condensing unit produces acidic water continuously while it runs, which has to be piped away and often passed through a neutraliser. With no sewer district serving this locality, the destination is an onsite system or a suitable outside point, and it is planned rather than improvised.
Electrical and location
Most gas tankless units need a power outlet for the controls and the fan, which is a small circuit but still a circuit. Electric tankless units are a different matter: they draw heavily and usually require a service upgrade, which on a rural parcel is a project of its own.
Location follows the clearances on the label, the vent route and the gas run. An interior wall shared with a utility space often works; an exterior wall in a dusty spot near orchard work does not, because the air intake will pull in what the wind is carrying.
Where tankless stops making sense
A household with modest demand, a sound storage tank and a tight budget usually gets more value from keeping the tank and maintaining it. The wall-hung option earns its cost when space is the constraint, when demand is genuinely continuous, or when a long run to a distant fixture is being solved at the same time.
The replacement page covers the storage route, the installation page covers the permit and the well-system details, and the maintenance page covers the descaling schedule that keeps a tankless unit working on a private supply.