The usual reason to consider tankless here is space. A manufactured home's utility closet is not built for a floor-standing tank, and a wall-hung unit gives the floor back. The usual reason a conversion fails is not the heater — it is the flue, the gas line and the drain.
Space, and what replaces it
Removing a tank frees the closet floor, which in a park space is genuinely useful. The trade is that a tankless unit needs clearances to combustibles from its own manual, a service access area in front of it, and a flue route that may not exist yet.
In the post-war houses, tankless usually goes where the old unit was or on an exterior wall, and the question shifts from space to venting and gas.
The flue decides more than the model
A tankless unit's venting is model-specific: category, length, termination and clearance all come from the installation instructions. In a manufactured home, the factory vent arrangement and the unit's instructions govern what can be done at all, and a conversion may not be permissible without changing the venting design.
That is checked first. Choosing a unit before the flue route is settled is how a conversion stalls halfway.
Gas, electricity and elevation
A tankless unit fires hard and briefly, drawing more gas at full input than a storage tank. The line from the meter is sized against the manual, the shutoff is replaced where it is old, and the sediment trap stays.
Electric tankless units shift the question to the panel: several kilowatts at once, which on these older houses usually means an electrical upgrade rather than a swap.
Elevation is not a factor at valley-floor height, unlike the high-desert locations on this site, so the manual's standard instructions apply.
Condensate, where it applies
A condensing unit produces acidic condensate that cannot simply run onto a park space's ground or into a planter. It needs a neutraliser and a suitable drain, and that is a design decision made before installation rather than an accessory added afterwards.
Water and descaling
No hardness figure is claimed here because the supplier could not be confirmed in this research. Scale remains the main threat to a tankless exchanger regardless of the source, and the interval for descaling should follow a test at the address.
A unit that loses temperature stability, faults on a cold morning or shows reduced flow is usually scaled or restricted at the inlet filter. Both are service items, not failures, if they are caught early.
Service and the permit
Descaling, filter cleaning and a flow check are the routine items. Installation, replacement and any change to gas or venting are permitted by Los Angeles County Public Works, Building and Safety Division through EPIC-LA — the county, not the cities next door.
Where the flue route or the gas line rules tankless out, a same-footprint tank is the sensible answer and the replacement page covers it. Where the unit is going in for the first time, installation covers the permit and clearance work, and maintenance is where the descaling schedule gets set.