A new water heater in North Pomona is a normal installation with a specific set of constraints: a county permit office for an address that reads like a city, and a building stock where the available space, not the household's demand, often sets the ceiling.
The permit goes to the county
Los Angeles County Public Works, Building and Safety Division permits plumbing and mechanical work on unincorporated addresses, and applications and inspections run through EPIC-LA. The cities that surround this island have their own counters and no jurisdiction over it.
Two things follow. The application is filed against a county parcel record, and the inspection is scheduled with the county. Neither is difficult, but both are easy to get wrong when the property next door is inside Pomona.
Fitting the space
In the park, the utility closet governs. Measure the opening, the depth, the platform height, the flue route and the clearance to any combustible surface, then read the manufactured home's data plate and installation instructions. A tank that fits the demand but not the closet is not an option, and the sensible alternatives are a shorter unit, a different shape, or a tankless unit on a wall, which has its own constraints, covered on the tankless page.
In the houses, the garage, hall closet or exterior alcove usually has room for a like-for-like swap but not always for an upgrade. A taller, wider tank can block a door swing, sit under a shelf, or push the vent into a roof member. Those are measured before the unit is ordered.
Venting and combustion air
A gas unit's flue is part of the installation, not an accessory. The vent has to rise, terminate correctly and clear combustibles by the distance the manual specifies, and the space needs combustion air that is genuinely open: a louvre painted shut is a closed door.
In a manufactured home, the factory venting arrangement and the instructions that came with the unit govern. In a post-war house, the existing vent may have been altered by a re-roof or a remodel, and that is where the installation becomes a small venting project.
Gas, electricity and the connections
On gas, the connector, the sediment trap and the shutoff are checked and replaced where they are older than the tank — which on these blocks they usually are. On electric, the circuit and the breaker are verified against the new unit's rating rather than assumed from the old one.
Seismic strapping applies either way. A unit on a stand is strapped to the structure, not only to the stand.
What the inspection looks at
The state's items: strapping, expansion control, relief valve discharge, venting, combustion air, and the garage clearance rule where a gas unit sits at floor level. The county inspects them; the code is the same code that applies in the neighbouring cities.
After commissioning
The unit is filled, purged, lit and run through a heating cycle so the relief valve and expansion tank are seen working, and the old tank leaves with the crew. The model, capacity, date and permit record stay with whoever owns the unit — in the park, that is usually the space owner rather than the tenant.
Where the existing tank is being replaced rather than added, the replacement page covers the decision; where the property is a park-owned set of units or a small commercial building, commercial service covers the wider scope.