A repair visit on a Del Sur parcel has two halves. One is the appliance: what the tank, the element, the gas valve or the flame is doing. The other is the property: what the well, the pressure tank and the check valve are doing to it. Sorting which half is at fault is most of the diagnosis, and it is where a caller's description helps most.
Pressure first, because it is free to check
Open a tap and watch a pressure gauge, or watch what the shower does when the washing machine fills. A system that sags under load is telling you about the well, not the heater. A pressure tank that has lost its air charge swings between high and low, and every swing works the tank, the fixtures and the relief valve.
The second pressure test is the relief valve. Water at the discharge tube when the burner has just run is a closed system with nowhere for expanded water to go. On a well property the check valve closes the plumbing, so an expansion tank is the part that is supposed to absorb that expansion, and a relief valve changed twice without one is a repair that never had a chance.
What the groundwater leaves behind
Sediment collects on the tank floor. Early on it is invisible; later the drain runs slow, and later still the lower element or the flue surface is insulated by scale and recovery stretches out. A tank that takes noticeably longer in July than it did in April is usually describing scale rather than weather.
Iron behaves differently. It stains, it tastes, and in some wells it feeds iron-related bacteria that leave a slick orange film in the tank and the toilet cistern. No water heater fixes that. A sediment filter ahead of the unit catches grit, and a lab test decides whether treatment belongs upstream. The maintenance page covers how the flush interval follows from the test.
The anode is a wear part
The sacrificial rod is what keeps the steel from corroding, and it is consumed rather than maintained. Pulling it is the cheapest inspection on the property: a rod with material left says the tank has time; a rod down to its core says the water is working hard and the next tank should be chosen with that in mind.
The same rod explains the sulphur smell that appears in some households. Before any treatment is discussed, the rod is inspected, because replacing it frequently ends the complaint.
When the complaint is the flame
Dust is the west side's contribution. Fine soil packs the air shutter, the burner intake and the vent screen, and the flame responds before the electronics do: yellow tips, a lazy pattern, soot at the draft hood, a unit that lights and then drops out. Cleaning the air path is the first move and the cheapest.
Two other causes are worth distinguishing on a windy parcel. A vent termination that faces the prevailing wind can cause a downdraft that puts the pilot or flame out, and a flue with a partial obstruction behaves similarly. Neither is fixed by a control board.
When repair is the wrong answer
A shell weeping from its body, a bottom plate that gives under the drain, or a tank that has already been patched is finished. Corrosion at the bottom seam is the usual ending on a well supply, and it is not repairable in any way that lasts.
That is the replacement page, which also covers why the fittings and the expansion tank are renewed at the same time. Water running right now belongs with the emergency page.
What to have ready when you call
The model and a photograph of the data plate, what the pressure does when two fixtures run, whether the house is on piped gas or a propane tank, and how the parcel is reached. On a community where the address reads Lancaster but the work is county territory, the parcel details also decide the permit, which the installation page explains.