Maintenance here has a different centre of gravity from the valley. Scale is a smaller problem than it is on well water, and freezing is a much larger one. The routine that matters is built around the cold, with the usual flush and anode work fitted inside it.
The autumn list
October is the month that earns its keep. Insulate or re-insulate every exposed run, including the short sections that leave a wall and re-enter it. Confirm the isolation valves at the heater actually close, because a valve that will not close defeats every later attempt to drain a line.
Where an outbuilding is served, make sure it can be drained and that the valve is accessible. Where an appliance condenses, check the condensate route and protect the exterior section.
Then look at the heater itself: the flue or vent termination clear of debris and growth, the relief discharge visible and unobstructed, and the temperature setting appropriate.
The annual core
Drain the tank and watch what comes out. On the mutual's water the deposit is usually fine sediment rather than heavy scale, and the volume tells you whether the interval should shorten.
Inspect the anode and replace it if it is substantially gone. It is the part that protects the steel, and it is cheap compared with a tank.
Exercise the relief valve and check the expansion tank's charge. A closed service connection makes expansion control essential, and a failed tank is silent until the valve starts dripping on every cycle.
Change the sediment filter if one is fitted, and note the loading rate. That number is the best measure of what the distribution system is delivering to the property.
Reading the supply
A mutual that buys its water and keeps wells for part-time use can change source. Taste, spotting and filter loading are the visible signs; a test is the evidence. Keeping a result on file means a future complaint can be compared rather than guessed at.
Where the property is outside the mutual and on a well, the same advice applies with more force: the well is the only report you will get, and the repair page covers the faults that follow from it.
Part-time occupancy
A house that is empty for weeks at a time has a different risk profile. The pipe that bursts does so unnoticed, and the damage is discovered on return. Isolating and draining the exposed runs before leaving, and leaving the heater on a freeze-protection setting rather than off, is the routine that prevents it.
The emergency page covers what to do when the discovery happens anyway.
The record
Keep one sheet with the equipment: the water test or supplier report, the model and serial, the expansion tank charge, the filter part number, the dates of each flush and the freeze measures taken. On a canyon property where the next technician may arrive with no history, that sheet saves a visit.
When maintenance stops being enough, the replacement page explains how the old unit's condition becomes the specification for the next one.