In a dense county island, the distance to the property is never the problem. The first minute is: finding the valve in a closet the size of a wardrobe, and stopping the water before it reaches a particleboard floor.
Stopping the water in a manufactured home
The shutoff is normally on the cold line where it enters the heater, inside the utility closet. Turn it clockwise. If it is seized, or the leak is below it, there is usually a valve on the supply line to the home — under the skirting at the connection point — and failing that, the park's own supply shutoff.
Then stop the heat: the thermostat on a gas unit, the breaker on an electric one. A tank that keeps heating while it drains can be damaged further, and a burner with water around it should not be relit until it is dry and checked.
If water is near a panel, a cord or an outlet, leave it and cut the power at the main.
In an older house
The valve above the tank, then the main at the meter or the property line. On these blocks the valve above the tank is frequently older than the tank and may not close fully, which is exactly why the main is worth knowing before the night it is needed.
The heat source off, the area cleared, and the water at the base confirmed: a tank leaking from its shell will not stop, and the replacement page is where that conversation goes once the water is off.
Gas is not the same emergency
A sulfur smell at the hot tap is a water-quality symptom and can wait for a service visit. The smell of gas is not. Leave the building, avoid switches, and call the gas utility from outside. The heater is examined afterwards, once the line is safe.
The same applies to a burner that will not stay lit, a flame that has gone yellow or a flue that spills at the draft hood: those are stop-and-check conditions, not diagnosis-by-telephone.
Water from above and below
Thompson Creek crosses the northwestern tip under the county Flood Control District's oversight, and a garage at the low end of a lot is where storm water arrives first. A heater standing in that water should be on a stand, with its ignition source above the floor; if it has been submerged, it is not relit — it is replaced.
In the park, a leak in a neighbouring space or a supply-line failure can put water under several homes at once, which is a call to the park as well as to a plumber.
What helps on the call
- the space number or street address, and which half of the community it is;
- whether the unit is in a closet, a garage or outside;
- the fuel, the tank type and roughly the age;
- what is happening: water, no hot water, noise, smell, a tripped breaker;
- whether the supply is already off, and who owns the unit if the space is rented.
The phone is answered around the clock. No arrival window is promised here, because a number quoted for a park space and a house block would be a guess dressed as a commitment.
After the water is off
With the valve shut, the worst of it is over. A shell that has failed goes to replacement; a valve, element or thermocouple goes to repair; an exposed run that survived the night belongs with maintenance, where insulation and a discharge line that drains are added before the next cold snap arrives.