A city connection can be isolated at one valve. A well parcel has three points to close, and the order you use them in decides whether the leak stops or the pump quietly refills the house while you are looking for a torch.
Three valves, in order
- The valve above the heater. On the cold line into the unit, and the quickest way to stop a leak that starts at the tank.
- The valve at the pressure tank. Isolates the house from the well.
- The pump control. A breaker or switch at the pump or the pressure-tank panel, which stops the system from refilling while the leak is dealt with.
Close the first; if it is seized, or the leak is below it, go to the second and then the third. Cutting the pump also protects the well from running dry through a burst line.
Then stop the heat
The thermostat to off on gas, the breaker to off on electric. A burner surrounded by water stays off until it has dried and been checked, and a tank that is emptying does not need to be heated.
Water near a receptacle, a cord or the panel changes the order: kill that circuit at the main first.
If the leak is at the pressure tank
Water at the pressure tank or the pump house is a well-system failure, not a heater failure, and the response is the same first move: cut the pump so the system stops refilling. A tank that has rusted through, a failed fitting or a split bladder all present as water where the equipment stands, and none of them is fixed by working on the heater.
The pump tells you something
A well pump that kicks on when nothing in the house is open is a clue that water is escaping somewhere — a tank at the end of its life, a split line, or a fixture running quietly. On a parcel that is empty for part of the year, that cycling is often the only warning anyone gets before the floor is wet.
Gas is a different call
Sulfur at the hot tap is a water question and can wait for a scheduled visit. The smell of gas cannot: leave the building, avoid switches, call the gas utility from outside.
A flame that has gone yellow, soot at the draft hood, a burner that drops out or exhaust smell indoors all mean stop and check. On a dusty parcel, a blocked intake or vent is a common cause.
Access details that save a trip
- the road, the turnoff and whether the last stretch is paved;
- gate or lock information, and whether the drive takes a loaded vehicle;
- which side of the house, and whether the unit is inside, in a garage or in an outbuilding;
- the fuel, the tank type and its rough age;
- what changed today: water, no hot water, a noise, an odour, a breaker that has tripped;
- whether the supply and the pump are already off.
The phone is answered at any hour. No arrival window is promised, because a desert parcel's access varies more than its distance.
After the water stops
A split shell means replacement; a valve, element or thermocouple means repair; a system that survived but has no expansion tank belongs with maintenance, where the expansion check and the flush interval are set before the next failure.
Where the property has an outbuilding or a farm building on the same supply, commercial service covers the wider shutdown.